5/19/2023 0 Comments Macos rumlogMake sure you do NOT do his before step 3 above!Ħ) Find out the correct port in your Windows Device Manager to use by looking for the "Microbit RRC Virtual COM Port (COM2)"ħ) Set your software to use the this COM port on your PC at -N. You don't need the problem for this, but this installs the correct drivers on your PC.Ĥ) Change the COM2 serial settings of the control-RRC to mode-4, 4800 baud, data bits 8, stop bits 1, "use USB Com Port as COM2" to "Yes" and submit/apply changes.ĥ) Plug a USB cable between your PC and control-RRC. This rate keeps traffic over the internet to a minimum and faster is not necessary for CAT.Ģ) Change the COM2 serial settings of the radio-RRC to mode-4, 4800 baud, data bits 8, stop bits 1 and submit/apply changes.ģ) Change the COM2 serial settings of the control-RRC to mode-4, 4800 baud, data bits 8, stop bits 1 and submit/apply changes.Ĥ) Plug a serial cable in between your PC and the control-RRC COM2ĥ) Set your software to use the correct COM port on your PC at -Nģ) Install the Microbit Setup Manager if you already haven't. Setup Icom 7300 On iMac With RUMLogNG 10,401 views 80 Dislike Share Save Ham Radio with K0PIR 10. RUMlog Link Additional MAC OS X HAM Radio Applications: Amateur Radio Ham Exam Prep 9.99 AudioRFX 9.99. The WinKeyer and few microHAM devices are supported. The data (log + trx) exchange with fldigi is supported. How can I ADIF export few QSOs only Select all desired QSOs in the logbook table and use Men>Logbook>Export ADIF. In both scenarios, you MUST first install a standard serial cable between the TS-480 body and COM2 of the radio RRC!ġ) Change the CAT rate on the TS-480 to 4800 baud (menu 56). Work CW, RTTY and other digital QSOs direct in the RUMlog application, using cocoaModem as interface. How can I edit multiple QSO Select all desired QSOs in the logbook table and use Menu>QSO>Edit QSOs. Ill just quickly jump in here as a MLDX, Flex, and former RUMLog user. Using the RC-2000, it would work just like the TS-480 as follows: If I run MacLoggerDX on a Mac Mini, would it be possible to use SmartSDR and. That was important information I was lacking before
0 Comments
Leave a Reply. |